When operating the veneer dryer, first open the loading door and place the dewatered wood onto the platform. Select the appropriate drying duration and turn the timer knob to the desired setting; then, press the "Start" or "Dry" button to activate the rotating drum and exhaust fan to commence the drying process. During operation, frequently observe the wood being dried through the observation window. In the event of an emergency, immediately cut off the power supply. If the machine malfunctions, stop the equipment immediately to identify the cause and resolve the issue promptly.
Regarding routine maintenance: the exhaust fan requires periodic lubrication. When operating the machine, ensure that the heating system is activated *before* starting the fan; never apply heat without the fan running. Additionally, if the drive chain becomes excessively loose, it must be adjusted immediately; similarly, any loose screws or fasteners throughout the machine should be tightened without delay.
Avoid overloading the machine by placing too many veneers inside at one time; ensure that the loaded veneers are of uniform thickness and consistent dimensions. During the drying process, pay close attention to the equipment's ventilation and heat dissipation. On a daily basis, clean the equipment and inspect, repair, or lubricate its various components as needed. During operation, take precautions to prevent fire hazards and ensure full compliance with national fire safety regulations. Prior to each startup, conduct a thorough inspection of the equipment; if any abnormalities are detected, suspend operation immediately and report the issue to a supervisor or maintenance personnel. During normal operation, if the internal temperature rises sluggishly, it may indicate the presence of condensed water within the steam supply; in such cases, open the drain valve to discharge the water.